Brookfield RVDV-II+Pro - III.3.6 Run a Program

Brookeld Engineering Labs., Inc. Page 37 Manual No. M/03-165-D0410
B.E.V.I.S. ERROR
NO PC ATTACHED
Figure III-36
A press of any key (except the MOTOR ON/OFF/ESCAPE key) will take the user back a level to
Figure III-34 where you may elect to download another program or, with a press of the MOTOR
ON/OFF/ESCAPE key, return to the screen of Figure III-33.
III.3.6 Run a Program
In the Options menu, scroll to the screen shown in Figure III-37:
DOWNLOAD A PROG è
RUNAPROG ê
Figure III-37
Press the ENTER/AUTORANGE key to run a B.E.V.I.S. program as shown in Figure III-38:
RUN PGM SLOT#1èê
PRESSENTER
Figure III-38
Using the UP/DOWN ARROW keys, select one of the four (4) stored programs. Press the ENTER/
AUTORANGE key. Any attempt to select a program slot that does not contain a program will
result in a double beep for each key press. When a valid program slot is selected, the screen in
Figure III-39 is displayed:
PRINT KEY = LIST
ENTER KEY = RUN
Figure III-39
At this point, you may elect to print the B.E.V.I.S. program by pressing the PRINT key or start
the program immediately by pressing the ENTER/AUTORANGE key (remember: pressing the
MOTOR ON/OFF/ESCAPE key will stop the current operation and bring you back one menu level).
You may elect to print the program, to conrm the slot choice as correct or simply to have it
available later when reviewing data. If you elect to print the program, you will return to the
screen of Figure III-38 after the program is nished printing. Pressing the ENTER/AUTORANGE
key exits the screen of Figure III-38 and the program will start running.
On program start, the screen could be any of the screens possible when running a B.E.V.I.S.
program. A typical screen might be: