To Next Page

To Previous Page

Brookeld Engineering Labs., Inc. Page 35 Manual No. M/03-165-D0410

Note: The value for minutes or seconds must be other than zero (0) or you will print

continuously when you exit this mode. A press of the MOTOR ON/OFF/

ESCAPE key would exit this option and take you back to the screen of Figure

III-28.

Continued pressing of the OPTIONS/TAB key will toggle between the minutes and seconds input

screens. Press the ENTER/AUTORANGE key to accept the new values for print interval in minutes

and seconds. You will now be in the screen display of Figure III-28 where you may re-enter

the print interval mode, or exit to the default screen (Figure II-5) by pressing the MOTOR ON/

OFF/ESCAPE key.

Activating print selections in the Print mode can only be done by exiting to the main menu

and pressing the PRINT key for four (4) seconds. “P%” will ash in front of the torque reading,

conrming that you are now in the Print Interval mode. Pressing PRINT for one (1) second

thereafter will disable the Print mode and remove the “P%” from the display.

III.3.4 PC Program (On/O)

This option causes the serial port of the DV-II+Pro viscometer to go into a high speed output

mode (approximately 3 print lines per second) for use with Brookeld WINGATHER®

software program. When ON, you may enter the Options menu but will not be allowed to

make any option selections until the PC PROG is turned OFF. All front panel keys will

function normally when you turn the option ON and return to normal viscometer operation by

pressing the MOTOR ON/OFF/ESCAPE key. When OFF, the DV-II+Pro will return to the last set

print time interval when printing is resumed.

Note:

WINGATHER® software can be used for data acquisition and analysis.

Rheocalc32 software can be used for complete external control of DV-

II+Pro.

From the Options menu, scroll to the screen shown in Figure III-31:

SET PRINT TIME è

D PCPROGOFF ê

Figure III-31

Press the OPTIONS/TAB key to display Figure III-32:

SET PRINT TIME è

D PCPROGON

Figure III-32

Pressing the OPTIONS/TAB key would return you to the screen display of Figure III-31. Repeated

pressing of the OPTIONS/TAB key would cause you to toggle back-and-forth between the displays

of Figure III-31 and Figure III-32.

To turn high speed output ON, press the ENTER/AUTORANGE key when the appropriate screen is

displayed. Then press the MOTOR ON/OFF/ESCAPE key to exit the Setup mode. This returns you

Brookfield RVDV-II+Pro User Manual

Questions and Answers: