EasyManua.ls Logo

Brookfield RVDV-II+Pro - Page 30

Brookfield RVDV-II+Pro
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Brookeld Engineering Labs., Inc. Page 30 Manual No. M/03-165-D0410
TIMED STOP
SET SEC’S: 00 èê
Figure III-16
Using the UP and DOWN ARROW keys, the user enters a value for the seconds portion of the time
ramp. This value will be from zero (0 ) up to fty-nine (59) seconds. Press ENTER to accept the
value.
Note:
The value for either minutes or seconds must be other than zero or you cannot
advance to the RPM input screen (Figure III-17). Pressing the OPTIONS/TAB
or ENTER/AUTORANGE keys will cause the user to alternate between the
minutes input screen (Figure III-15) and the seconds input screen (Figure III-
16) until either minutes or seconds are anything but zero.
A press of the ENTER/AUTORANGE key allows the user to input the RPM selection. At this point,
the user will see a screen similar to Figure III-17; using the UP and DOWN ARROW keys, the
user sets the speed.
TIMED STOP
SELECT RPM:30 èê
Figure III-17
After selecting the speed, the user may review the values selected. If the user presses the
OPTIONS/TAB key, you will return to the minutes input screen of Figure III-15 where you
may change the minute input if so desired. Thereafter, continued pressing of the OPTIONS/TAB
key will toggle between the minutes and seconds input screens and the motor input screen. A
press of the MOTOR ON/OFF/ESCAPE key will cancel the timed stop operation and take the user
back to the screen of Figure III-14. Pressing the ENTER/AUTORANGE key will cause the DV-
II+Pro to accept the new values.
That done, the user is presented with the following screen:
TIMED STOP
ENTER TO START
Figure III-18
At this point the user must press the ENTER/AUTORANGE key to begin the timed stop operation.
Any other key press will be ignored except the MOTOR ON/OFF/ESCAPE key which will cancel the
process and take the user back to the screen of Figure III-14 where you will have to begin all
over again.
We will assume that the user pressed the ENTER/AUTORANGE key. You will now be presented
with the following screen for the duration of the timed run:

Table of Contents

Related product manuals