Brookfield RVDV-II+Pro - Page 42

Brookeld Engineering Labs., Inc. Page 42 Manual No. M/03-165-D0410
Figure IV-2 shows the grid where the operator programs are created.
It is used to view and edit the B.E.V.I.S. programs. When the
software starts, an empty grid appears on the left of the screen. You
can choose up to 25 commands for your program. Highlight each
command in the list box to the right of this grid, then click on the
Insert button to insert that same command into the highlighted line
of the grid. This same insertion task can also be accomplished by
double-clicking on the appropriate command in the list box to the
right.
In the case of a speed command (SSN), the Speeds list box becomes
enabled when the cursor is placed in the parameter column for
an SSN command. Click on the down arrow to display a list of
available speeds. Click on the desired speed, and it will be inserted
into the appropriate parameter column in the program grid. The same
applies to the spindle command (SSP).
Select the COM (RS-232) port the Programmable DV-II+Pro Viscometer is connected
to from the COM Port drop down list.
Click the Open File button to load existing B.E.V.I.S. programs.
Click the Save File button to save the B.E.V.I.S. program displayed in the grid.
Click the Print button to print the B.E.V.I.S. program displayed in the grid.
Click the Insert button to insert the B.E.V.I.S. command selected in the Commands box
into the selected row in the program grid.
The buttons shown on the main screen are explained below.
Figure IV-2
1 SSN 50.0
2 WTI 00:30
3 SPI 00:05
4 WPT 75 .0
5 SSN 25.0
6 WTI 00:10
7 WPT 75 .0
8 SSN 0.0
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25