Brother BAS-342G - Page 114

7. ADJUSTMENT
105
BAS-342G
5
1) Remove the feed plate.
2)
Place the rear edge of the home position reference plate (1) against the stepped part of base plate Y (2) (shaded
section (A)) and use a 2 mm diameter pin (such as a needle) to align the hole in the home position reference plate
(1) with the hole in base plate Y (2); then tighten the two bolts (3).
3) Press the or key to change the offset value (-999 to 999) so that the needle drops to the center of the mark
(B) on the home position reference plate (1).
・ The home position reference plate (1) will move in accordance with the setting value.
6
Press the RESET key.
・ Home position detection will be carried out. Check the
home position. If the home position is correct, remove
the home position reference plate (1), and then install
the feed plate. (Refer to "7-10-1. Installing the feed
plate".)
7
End adjustment mode.
TEST indicator switches off
Press the TEST key.
・ The display will return to the normal display and the
sewing machine will change to home position standby.
NOTE:
Be sure to press the RESET key to check the home position before ending adjustment mode. If adjustment mode is ended
without checking the home position, error “E202” will be generated.