Brother BAS-342G - 8. USING CF CARDS; 8-1. Notes on handling CF cards

5. DISASSEMBLY
BAS-342G
47
5-7. Lower shaft mechanism
1. Bolt (Loosen)
2. Driver
3. Set screws [2 pcs] (Loosen)
4. Set screws [2 pcs] (Loosen)
5. Set screws (Loosen)
6. Lower shaft bush
7. Lower shaft assembly
(Pull out from the rear of the machine)
8. Set screw collar
9. Set screw collar
10. Set screw (Loosen)
11. Lower shaft M bush
12. Set screw (Loosen)
13. Adjusting stud (Pull out)
14. Set screw (Loosen)
15. Adjusting stud (Pull out)
16. Set screw (Loosen)
17. Shuttle race base assembly
18. Set screws [2 pcs] (Loosen)
19. Bolt (Loosen)
20. Pinch sleeve A
21. Pinch sleeve B
22. Set screw (Loosen)
23. Set screw collar R
24. Set screws [2 pcs] (Loosen)
25. Rock gear shaft
(Pull out from the rear of the machine)
26. Set screw collar B
27. Rock gear
28. Crank rod [Lower part]
1246B
If the adjusting stud will not pull out,
insert a M3 screw into the tap hole and
then pull out the adjusting stud.
1244B
1245B
Remove the rock gear and the cran
k
rod together as a single unit.
1247B