Brother BAS-342G - 11-2. Adjusting arm thread guide R; 11-3. Adjusting the needle bar height; 11-4. Adjusting the needle bar lift amount

6. ASSEMBLY
BAS-342G
56
21. Thread driving leve
r
22. Thread trimmer collar
23. Collar shaft
24. Retaining ring E
25. Set screw
26. Thread trimmer rod V
27. Shoulder screw B
28. Nut
29. Guide shaft
30. Compression spring
31. Cushion
32. Set screw
33. Thread trimmer solenoid
34. Solenoid bracket
35. Plain washers [2 pcs]
36. Spring washers [2 pcs]
37. Bolts [2 pcs]
38. Solenoid cushion
39. Washer
40. Solenoid lever
41. Set screw
42. Bolts with washers [2 pcs]
43. Driving lever pushing lever
44. Shoulder screw
45. Set screw
46. Nut
47. Movable knife connecting plate
48. Shoulder screw
49. Shoulder screw B
50. Nut
51. Plain washer
52. Spring washer
53. Bolt
When the ball joint assembly of the
thread trimmer rod V (26) has been
disassembled, assemble it so that
the distance between the centers o
f
the holes is 287.5 ± 0.5 mm.
4615Q
1270B
1269B
Tighten the set screw (25) on the
screw stop while lightly pressing the
collar shaft (23).
Check that the thread trimmer colla
r
(22) turns smoothly.
A
ssemble so that the wick is
hanging down.
A
pply grease.