Brother BAS-342G - Page 73

6. ASSEMBLY
BAS-342G
64
37. Y motor assembly
38. Bolts [4 pcs]
Move the feed plate in the Y direction so that the center of the feed
plate is aligned with the center of the needle hole, and then install the
Y
motor so that the index mark on the end of the Y motor shaft is facing
directly upward.
1286B
Index mark
Y direction
Center
Center of needle hole
A
djust and install so
that the backlash is
w
ithin 0.01 to 0.05.
1287B