Brother GTX-4 - Page 148

4-51
Improvement of print quality
X0205
Cleaning conditions
Pre-cleaning state Post-cleaning state
(8)
Close the front cover, turn on the power.
(9)
From the menu, select [Head Cleaning] > [Powerful Cleaning] > [All Print Heads], and press
.
<NOTE>
 Dispose of any waste resulting from the cleaning in accordance with applicable laws and ordinances.
<TIPS>
 Then, the head cleaning will be performed to prevent any ink from drying up.
 Because the cleaning cup will be reused, rinse it in clean cleaning solution and store it in a safe place.
(10) Print out a nozzle check pattern to check the result.
 If non-ink ejection nozzle is not found -> OK
 If the state of non-ink ejection nozzle is not changed -> NG
=> "(12) After replacing the wiper cleaner, is such failure cleared?"