Brother GTX-4 - Assembly of Solenoid Valve A, B, C, K, L, and M

6-207
Disassembly / Replacement / Adjustment
(6) Put a mark on the tube connected to the solenoid valve to be replaced so as to put it back in place, and detach the
tube from the valve nipple. (Shown in the photo is valve A.)
(7) Disconnect the relay connector of the target solenoid.
(8) Remove the screw fixing the target solenoid valve to detach the solenoid valve.
Assembly of solenoid valve A, B, C, K, L, and M
(1) To perform the assembly, take the reverse procedures to disassembly operation.
Put a mark.