Brother GTX-4 - Replacing the Wiper Cleaner Sensor; Assembly of Wiper Cleaner Sensor

6-203
Disassembly / Replacement / Adjustment
Replacing the wiper cleaner sensor
(1) Turn the cleaner cam by hand to align the cam notch to the sensor part.
(2) Loosen the screw fixing the sensor circuit board.
(3) Detach the sensor circuit board.
Assembly of wiper cleaner sensor
(1) To perform the assembly, take the reverse procedures to disassembly operation.
Connect to
Maintenance
circuit board CN1
Connect to Maintenance circuit board CN24
2
1