Brother GTX-4 - Page 179

5-14
Regular Maintenance
(12) Insert the two latches under the encoder cover and fix the cover with three screws.
(13) Close the front cover.
(14) Turn on the power.
<NOTE>
 Dispose of any waste resulting from the cleaning in accordance with applicable laws and ordinances.
<TIPS>
 Then, the head cleaning will be performed to prevent any ink from drying up.
 Because the cleaning cup will be reused, rinse it in clean cleaning solution and store it in a safe place.
(15) Adjust the carriage speed.
<TIPS>
 For details, refer to "2-5-1. CR (Carriage) speed adjustment".
(16) Print out a nozzle check pattern.
<TIPS>
 Refer to "7-2-1. Print out of the nozzle check pattern (checking on the print heads)" of the Instruction Manual.