Brother GTX-4 - 8-7. Setup of Auto Screen Erase Time; 8-8. Setting the Menu Timeout Period

6-37
Disassembly / Replacement / Adjustment
Assembly
(1) To perform the assembly, take the reverse procedures to disassembly operation.
(2)
Adjust the carriage speed after attaching the cover. While the printer is in standby mode, press
on the
operation panel to bring the menu screen into view.
(3)
From the menu, select [Printer Setting] > [CR Speed Adjustment], and press
.
(4)
Select [Start (after cleaning/setup)] and press
.
<TIPS>
 Wait until the carriage stops moving and the sound of pong is heard.
 It takes about 3 minutes to adjust the carriage speed.
Please Wait
Auto Adjusting
CR Speed Adjustment