Brother GTX-4 - 9-2-6. Replacement of Print Head

6-73
Disassembly / Replacement / Adjustment
Assembly
(1) To perform the assembly, take the reverse procedures to disassembly operation.
(2) Attach large and small rubber caps to the maintenance unit.
<IMPORTANT>
 Use hands to prevent damages to the cap rubbers.
 Make sure the rubbers are securely attached.
Concerning cap rubber small, the tabs on the rubber should be securely lodged into the left / right holes on the sides of the
holder.
(3) Attach large and small caps onto the maintenance unit.
<CAUTION>
 Front / Rear and sides are designated for the large and small caps.
Top side
Rearward
Rearward
Top side
Cap rubber large
Tabs on cap rubber small
Cap rubber small