6-80
Disassembly / Replacement / Adjustment
(7) Attach the filter so that the INLET mark may face toward the upstream of the flow passage (in the direction of the
cartridge).
<IMPORTANT>
ï‚· Be sure to check the filter direction.
Assembly
(1) To perform the assembly, take the reverse procedures to disassembly operation.
(2) Before turning on the power, change the capping pouch to the white ink pouch.
After finishing the assembly, turn on the power.
(3) After turning on the power, conduct the ink installation following the on-screen instructions.
(4) To replace other filters, please perform the same procedures from Step 1 again.
INLET mark
INLET mark
To Next Page
Loading...
