Brother GTX-4 - Page 285

6-94
Disassembly / Replacement / Adjustment
(4) Remove the connection of the fitting on the head side.
Attach a fitting (the one attached with a new tube) to the fitting-detached portion to prevent the ink from leaking.
(5) Detach the tube from the tube clamp.
<CAUTION>
 When detaching the tube from the tube clamp (SB5380), avoid bending the tube as much as possible.
<TIPS>
 The operation of Step 5 through 9 describes the replacement procedures for W1 but also applies to other tubes.
(6) Detach the fitting.
Attach a fitting (the one attached with a new tube) to the fitting-detached portion to prevent the ink from leaking.
Attach the fitting.
Release the lock and
lift upward.
6
K Y C M W1 W2 W3 W4 W4 W3 W2 W1
Attach the fitting.