Brother GTX-4 - Page 299

6-108
Disassembly / Replacement / Adjustment
(14) Remove the resin cover which is placed on the top of the carriage board carriage board.
(15) Open the hold-down clip for cable, and remove the flat cable.
X013
5
(16) Unlock the print head, and remove the print head.
<IMPORTANT>
 When removing the print head, be careful not to drip the ink on the carriage plate. If the ink is dripping, wipe off the dripping
ink.
②
①
X007
2
Lock
Print head
Resin cover
Flat cable
Hold-down clip for cable