Brother GTX-4 - Page 307

6-116
Disassembly / Replacement / Adjustment
(32)
Close the lid, and put the white ink cartridge in position inside the printer.
<IMPORTANT>
 W12 and W34 cartridges should correctly be placed at their original locations. Wrongly placed cartridges could cause a
printer malfunction.
(33)
Repeat the same process to replace the other capping cartridge with the white ink pouch.
(34)
On the operation panel, press
.
Then, the white ink will be installed after the head is replaced with a new one.
<TIPS>
 After the procedures are completed, the current screen will go back to the standby mode screen.
(35) Adjust the carriage speed.
<TIPS>
 For details, refer to "2-5-1. CR (Carriage) speed adjustment".
(36) Perform the V-rating settings configuration.
<TIPS>
 For details, refer to "2-5-2. V-rating setting".
(37) Adjust the ejection timing of the print head.
<TIPS>
 For details, refer to "2-5-3. Firing adjustment".
(38) Perform the platen feed adjustment.
<TIPS>
 For details, refer to "2-5-4. Platen feed adjustment".
(39) Make the position adjustment between the white head and the color head.
<TIPS>
 For details, refer to "2-5-5. White/color alignment".