Brother GTX-4 - Page 320

6-129
Disassembly / Replacement / Adjustment
(5) Install the lid to the cartridge. After installation, check if the wind-up shaft is inclined.
<TIPS>
 The protrusion of the lid comes in contact with the gear pressure plate in the middle of installation. But you can install the lid
by simply sliding it.
<CAUTION>
 Install the lid so that its grooves engage with the ribs of the cartridge.
(6) Install the ink level detection plate spring.
<CAUTION>
 Correctly orient the ink level detection plate spring when installing it.
Ink level detection plate spring
OK NG
If not correctly
installed, the hooks
are too far to easily set
the ink level detection
plate spring, possibly
resulting in removal of
the s
p
rin
g
.
Protrusion