Brother GTX-4 - Page 375

6-184
Disassembly / Replacement / Adjustment
(9) Align the 9.8 in. (250 mm)-marked position of the FFC at the tip of the FFC support.
(10) Extend to cover the FFC sleeve up to the position shown below.
(11) Fold the FFC as shown in the photo below and fix the FFC sleeve and FFC support on the two FFC clamps on the
rear of the carriage circuit board bracket.
9.8 in. (250 mm)
Marking
11
Thread FFC through
FFC clamp
FFC sleeve
9.8 in. (250 mm)
Marking
FFC support
a
a/2
Nub of the FFC suppor
t
to be located
on plating
Fix FFC clam
p
Orient protruding within
FFC support
to the left of
the FFC clamp, and
fix FFC clamp
Thread FFC through
rear-front side of the FFC clam
p
.