Brother GTX-4 - Page 377

6-186
Disassembly / Replacement / Adjustment
(13) Fold the FFC perpendicularly on the right of the FFC support bracket and fix the FFC on the two M-shaped clamps
on the rear of the main unit.
(14) Put the FFC through the bushings of the right top rear of the main unit and the right rear inside the main unit
sequentially.
(15) Make the HEAD_PW_W FFC (16P) formed as shown in the photo below.
(16) Make the HEAD_SIGNAL FFC (45P) formed as shown in the photo below.
0.04 to 0.08 in.
(1 to 2 mm)
1.4 in.
(35 mm)
0.04 to 0.08 in.
(1 to 2 mm)
2.9 in.
(74 mm)
13
14