6-214
Disassembly / Replacement / Adjustment
Replacement of remaining ink level detection circuit board (M, C)
(1) After opening the cover, open the tube clamp located at the following position of the right rear inside the main unit to
detach the tube.
(2) Disconnect the six connectors of the harness extending from the remaining level detection circuit board.
(3) Detach the circulation pump motor harness and the harness extending from the remaining level detection circuit
board from the clamps.
(4) Loosen the two screws fixing the ink supply sub assy to detach it.
2
2
3
4
Ink supply sub assy
1
To Next Page
Loading...
