6-216
Disassembly / Replacement / Adjustment
Replacement of remaining ink level detection circuit board (W12, W34)
(1) Remove the screw fixing the filter support plate of the target block to detach it.
(2) Take out the cartridge of the target block, replace the white ink pouch with the capping pouch, and then insert the
ink cartridge into the main unit.
(3) Detach the joint coupling the needle and filter and put a cap on the joint so that the ink may not spill out.
Head fitting stopper (SB5555)
Joint
3
Cap
1
W34
W12
Filter support plate
To Next Page
Loading...
