Brother GTX-4 - Page 425

8-8
Error code list
Error Error message Description Remedy
2062 (No message)
Even when turning the platen
motor for unloading, the origin
sensor does not turn on. (The
error message is not
displayed on the panel but is
recorded in the log.)
Check the platen motor and belt.
Check the platen origin sensor.
Replace the main circuit board.
2063 (No message)
Even when turning the platen
motor for loading, the origin
sensor does not turn off.
2070 [Obstacle on the Platen]
An obstacle was detected on
the platen.
(1) Check to see if the wrinkles or unevenness of
the T-shirt contact the obstacle sensor.
(2) Check to see if there is any lack of smoothness
in the platen movement.
(3) Use the [Input Check] of Advanced menu to
check to see if the obstacle sensor properly works.
2071
[Obstacle detected during
printing. Perform test print
to check ink discharge
from head]
An obstacle was detected on
the platen during printing.
(1) Check to see if the wrinkles or unevenness of
the T-shirt contact the obstacle sensor.
(2) Check to see if there is any lack of smoothness
in the platen movement.
(3) Use the [Input Check] of Advanced menu to
check to see if the obstacle sensor properly works.
(4) Perform test print to check ink discharge.
2080
Black
Check the cartridge.
It refers to the failure in the (K)
pouch winding.
Check to see if the pouch is properly wound.
Check for the movement of the cartridge winding
shaft.
Make the pouch uniformly flatted to set it properly.
(See "4-2. How to solve ink pouch wind-up failure")
2081
Magenta
Check the cartridge.
It refers to the failure in the
(M) pouch winding.
2082
Cyan
Check the cartridge.
It refers to the failure in the
(C) pouch winding.
2083
Yellow
Check the cartridge.
It refers to the failure in the (Y)
pouch winding.
2084
[White 12 Check The
Cartridge]
It refers to the failure in the
(W12) pouch winding.
Check to see if the pouch is properly wound.
Check for the movement of the cartridge winding
shaft.
Make the pouch uniformly flatted to set it properly.
Check for the movement of the cartridge ink
detection plate.
Check to see if the remaining ink level sensor
properly works.
(See "4-2. How to solve ink pouch wind-up failure")
Check to see if the pouch is not refilled with ink.
2085
[White 34 Check The
Cartridge]
It refers to the failure in the
(W34) pouch winding.
2100
[USB flash drive Not
Ready]
A USB flash drive is not
inserted.
The USB flash is not
recognized.
Try the solution method for the same error code of
"9-3. Error message" in the instruction manual.
Check to see if the USB insertion slot of the main
circuit board is deformed or damaged.
Electric components as candidate for replacement:
Main circuit board