2-16
Confidential
Error
codes
Problem
Refer
to
Error
codes
Problem
Refer
to
7D
Detected discharge that may be
attributable to dirty corona wire
on the drum unit.
2-37 90 An unidentified error occurred. 2-42
7E An unidentified error occurred. 2-37 91 An unidentified error occurred. 2-42
7F
The paper size set on the machine is
smaller than the specified fax size.
2-38 92 An unidentified error occurred. 2-42
80
The registration front sensor
detected that the paper set in the
paper tray was smaller than the
specified size.
2-38
93 An unidentified error occurred. 2-42
81 An unidentified error occurred. 2-38 94 An unidentified error occurred. 2-42
82 An unidentified error occurred. 2-38 95 An unidentified error occurred. 2-42
83
Detected discharge when the
number of rotations of the drum
has exceeded twice the life limit.
2-39
96 An unidentified error occurred. 2-42
84
The eject sensor remains ON
(paper pass detected) for more
than the specified time even
after the registration rear sensor
detected the end of paper pass.
2-39
97 An unidentified error occurred. 2-42
85 An unidentified error occurred. 2-40 98 An unidentified error occurred. 2-42
86 An unidentified error occurred. 2-40 99 An unidentified error occurred. 2-42
87 An unidentified error occurred. 2-40 9A
The registration front sensor
detected that there was no paper
set in the manual feed slot when
feeding from the manual feed slot
was set.
2-43
88
The eject sensor does not detect
paper pass after the registration
rear sensor detected the end of
paper pass.
2-40 9B
The number of rotations of the
developer roller reached the
upper limit when Continue Mode
is set for the toner cartridge.
2-43
89 An unidentified error occurred. 2-40 9C
The number of rotations of the
developer roller will reach the
upper limit soon when Continue
Mode is set for the toner cartridge.
2-44
8A
The registration front sensor
does not detect paper pass within
the specified time.
2-41 9D An unidentified error occurred. 2-44
8B An unidentified error occurred. 2-41 9E An unidentified error occurred. 2-44
8C An unidentified error occurred. 2-41 9F
The registration front sensor
detected that the paper has run
out when faxing or printing a list
or report.
2-45
8D
When the power switch was
turned ON, the eject sensor
detected paper pass or detected
that the fuser unit cover was open.
2-42 A0 An unidentified error occurred. 2-45
8E An unidentified error occurred. 2-42 A1
The front cover sensor detected
that the front cover was open.
2-46
8F An unidentified error occurred. 2-42 A2
The document scanning position
sensor detected that the document
length was 90 cm or more while
scanning the document.
2-46
To Next Page
Loading...
