Brother MFC-9125CN - Page 358

5-131
Confidential
Fig. 5-150-2
Fig. 5-150-3
Assembling Note:
- If the removed Earth plate L and Earth plate R are bent even a little, it will cause a
connection failure, and therefore they cannot be reused. Be sure to use the new Earth
plate L and Earth plate R when you assemble them.
- After assembling the Earth plate L and Earth plate R, be sure to check that they are firmly
engaged with the Hook A and Hook B, and not lifted from the LED ASSY.
(Refer to Fig. 5-150-2)
- The Hook of the Earth plate R must be firmly engaged with the Earth spring R.
(Refer to Fig. 5-150-3)
LED ASSY
Earth plate R
Earth plate R
LED ASSY
The Earth plate L and Earth plate R must not be lifted.
HookEarth spring R
LED ASSY
LED ASSY
Earth spring R
Earth plate R
Earth plate R