Brother MFC Series - Adjustment of Software Correction for Inclination;Corrugation;Ruled Lines; Margin Adjustment in Borderless Printing (Maintenance Mode 66); Update the Paper Feeding Correction Values (Maintenance Mode 58); Write Head Calibration Data (Maintenance Mode 02)

4-15
Confidential
Head/carriage Unit Inclination Adjustment Test Pattern
2.5 Adjustment of Software Correction for Inclination/Corrugation/Ruled
Lines (Maintenance mode 65)
Refer to Chapter 5 "1.4.20 Adjustment of Vertical Print Lines/Software Correction for
Inclination/Corrugation/Ruled Lines (Maintenance mode 65)" for details on how to adjust
software correction for inclination/corrugation/ruled lines.
2.6 Update the Paper Feeding Correction Values (Maintenance mode 58)
Refer to Chapter 5 "1.4.17 Updating of Paper Feeding Correction Value (Maintenance
mode 58)" for details on the execution.
2.7 Margin Adjustment in Borderless Printing (Maintenance mode 66)
Refer to Chapter 5 "1.4.21 Margin Adjustment in Borderless Printing (Maintenance mode
66)" for details on the execution.
2.8 Write Head Calibration Data (Maintenance mode 02)
Refer to Chapter 5 "1.4.2 Creating of Head Calibration Data and Writing it into Flash ROM
(Maintenance mode 02)" for details on the execution.