CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-34
(3) Disconnect the three cables.
NOTE:
• After disconnecting flat cable(s), check that each cable is not damaged at its end or
short-circuited.
• When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cables are not at an angle.
Fig. 4-58
(4) Remove the two cup B M3x8 Taptite screws, and then remove panel PCB ASSY.
Fig. 4-59
Panel cover
Lock
Cables
1
2
Lock
Cable
Taptite, cup B M3x8
Panel cover
Hooks
Panel PCB ASSY
1
2
To Next Page
Loading...
