BRP ROTAX 912 Series - Page 74

BRP-Rotax
MAINTENANCE MANUAL LINE
NOTE
If there is a large amount of resistance at a gap of approximately 10 mm, the bear-
ing rollers of the roller bearing may not be in position.
Figure 5.9: TYPICAL
1 Allen screw M8 2 Allen screw M6
Step
Procedure
11 Tighten 2 Allen screws M8x45and 8 Allen screws M6x45 with washers
6.4 diagonally from each other.
Tightening torque M6: 10 Nm (89 in.lb.).
Tightening torque M8: 25 Nm (18 ft.lb.).
05–50–00
Page 10
January 01 2020
Effectivity: 912 Series
Rev. 0