PULSE Multi-analyzer System Type 3560-B/C/D/E – Installation and IDAe Hardware26
Fig.2.17
Multiple frame setup
Fig.2.18
Setting the frame IP
address
From the Front-end Configuration page you can set up the IP address for the frame.
Note: You can reconcile the individual IP address with a physical unit in a later step
with the use of an RS–232 connection.
The default IP address is set to 10.10.10.11 to initiate a point-to-point connection with the
PC, which has the default address of 10.10.10.50. (All subsequent frames will also be in the
same network range.)
To Next Page
Loading...
