Bruker AVANCE - Required Rigging Equipment

Magnet Access and Rigging
H157655_1_008 31
4.4 Rigging Equipment
Rigging equipment is not included with the NMR system order. The following rigging
equipment will be needed for a typical delivery and installation of an NMR magnet system:
• Pallet Jack and/or Fork Lift: For transporting system magnet and accessories to the
laboratory.
• A-Frame or Lifting Hook: An A-Frame or lifting hook may be used inside the laboratory
during assembly phase. When a lifting hook is used, the hook capacity must be certified to
hold the required weight of the magnet before installation!
Figure4.1: A-Frame Gantry for Lifting the Magnet Inside the Magnet Room