Bruker CryoProbe - Figure 3.4. Status Display by the Control Buttons; Warm-Up Needed Soon

20 (107) BRUKER CryoProbe User Manual
System description
Status display by the control buttons
After pressing
UNPLUG, any sensor cable can be removed from the CryoProbe
during ~1 min without causing an error.
E
RROR reset
E
RROR may light up in any of the above situations (Figure 3.4.) in addition to the
lights displayed. To reset the E
RROR on the CryoCooling Unit front panel, press
cool
down
Power off
Power-up bulb test
Flushing
(preparing cool-down)
Cooling down
Ready cold
Almost cold /
(reduce decoupling!)
Warm-up needed soon
Warming up with Warming up without
Ready to unplug
CryoProbeactive heating active heating
Status lights:
= off
= on
= blinking
slightly over-heated
Cooling down,
ready for tuning
and shimming
Warm
warm
up
Cold
Error
un-
plug
Warm
warm
up
cool
down
Cold
Error
un-
plug
Warm
warm
up
cool
down
Cold
Error
un-
plug
Warm
warm
up
cool
down
Cold
Error
un-
plug
Warm
warm
up
cool
down
Cold
Error
un-
plug
Warm
warm
up
cool
down
Cold
Error
un-
plug
Warm
warm
up
cool
down
Cold
Error
un-
plug
Warm
warm
up
cool
down
Cold
Error
un-
plug
Warm
warm
up
cool
down
Cold
Error
un-
plug
Warm
warm
up
cool
down
Cold
Error
un-
plug
Warm
warm
up
cool
down
Cold
Error
un-
plug
Figure 3.4. Status display by the control buttons