Sample spinning test
CryoProbe User Manual BRUKER 33 (107)
Sample spinning test 4.4
0
Spinning test
Insert a typical sample into the magnet and check if it can be spun. Remove the
sample after the test.
IMPORTANT: No sample must be in the magnet during the CryoProbe cool-
down. Insert samples only if the C
OLD button on the CryoCooling Unit is on or at
least flashing.
For recommendations on sample tube quality, filling heights, and spinners, refer
to the CryoProbe System User Manual, "Samples and spinners" on page 55
.
If spinning does not work, see "Spinning problems" on page 74
.
Figure 4.6. Final positioning of the CryoProbe
m.12
m.13
To Next Page
Loading...
