3. Lift the center piece from the water tank and place it on the
side surface (Fig. 65).
ð
The UV degermination system is located below the
center plate next to the pump (Fig. 66/1).
4. Check the stainless steel pipe for damage and contamina-
tion. If necessary, remove contamination using a cloth and
lime remover.
5. Take the pump hoses off the stainless steel pipe and clean
them using the cleaning brush. In the event of severe con-
tamination or wear, replace the pump hoses.
Fig. 65: Removing the center piece
Fig. 66: UV degermination system
Fig. 67: Cleaning the pump hoses
Accessories
Evaporation Humidifier B500 Professional68
To Next Page
Loading...
