EasyManua.ls Logo

BTEK T401S - General Weighing with Accumulation Application

BTEK T401S
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
T401S Indicator User Instructions 15
3.2 General Weighing with Accumulation application
3.2 General Weighing with Accumulation application
This section applies if the Accumulator application is active.
3.2.1 SELECT key default function
In the Accumulator application you can view the Gross, Net, Tare, Gross Total, Net
Total and Transaction Count display values by repeatedly pressing SELECT.
When the Gross Total is displayed, both the GROSS and TOTAL annunciators will be
lit. When the Net Total is displayed, both the NET and TOTAL annunciators will be lit.
When the Transaction Count is displayed, the TOTAL annunciator is lit.
3.2.2 Accumulator operation
The accumulator application can be used to record totals of individual weighments.
Follow these steps:
1. Press ZERO to zero the scale, if necessary …
0 is displayed.
2. Place item on the scale …
Weight is displayed.
3. Press PRINT to add weight to the accumulator and to print the selected print
format …
The PRINT annunciator lights briefly.
4. Remove weight from the scale. Weight must return to inside the gross zero
band before another print and accumulation can be recorded.
5. Repeat steps 2 through 4 for each weighment you want to accumulate.
If enabled, press and hold PRINT for three seconds to print and/or clear the active
accumulator values. These functions are enabled or disabled in a password protected
menu.
You can use gross or net weighing with the accumulator application as it stores both
gross and net totals. You have one accumulator channel that is active all the time.
Press SELECT to toggle through the current values. When annunciators TOTAL &
GROSS are lit this indicates the total for the gross value. When annunciators TOTAL
& NET are lit this indicates the total for the net value. When annunciators TOTAL &
TARE are lit this indicates the total for the tare value. When TOTAL only is lit this is
the current number of transactions.
You can press the F1 key to add the weight to the accumulator without performing the
print function.

Table of Contents