T401S Indicator User Instructions 39
8 Supervisor menu
This menu allows a supervisor to change those functions of an application that are
configurable. Access the supervisor menu using the password 1793. Refer to
Accessing the menus on page 25 for instructions.
The Supervisor menu changes based on the active application. Go to the appropriate
section.
l General Weighing application supervisor menu on page 40
l Accumulator application supervisor menu on page 45
l Counting application supervisor menu on page 48
l Checkweighing application supervisor menu on page 51
l Batching application supervisor menu on page 54
l Peak Hold application supervisor menu on page 57
l Remote Display application supervisor menu on page 59
Wherever there is an option to print information in the any of the supervisor’s menus,
the information will print out of Port 1 or Port 2, whichever is configured.
The menus are always explained in a sequential manner to cover all information in a
logical fashion. You will probably never access all the menu items in this manner. You
can navigate to the area of the menu that needs to be changed by using the
navigation key chart shown with the menus.
Use the Numeric entry procedure on page 11 when you need to enter values.
To Next Page
Loading...