32 T401S Indicator User Instructions
Menus
5. Press ZERO …
3 XXX is displayed. This is third octet of the IP address.
6. Press ZERO …
4 XXX is displayed. This is fourth octet of the IP address.
7. Press ZERO …
iP Addr is displayed.
8. Press UNITS …
Subnet is displayed.
9. Repeat this sequence of key presses for the Subnet, Gateway and MAC
addresses.
10. When finished press TARE …
EnEt is displayed.
4.6.5 Dload
About Boot Firm App Serial Enet Dload
1. From EnEt, press UNITS …
dLoAd is displayed. This stands for download. Under SSEriAL you can
view the serial number of the software application that created the
configuration file. Under dSEriAL you can view the serial number of the
software application that downloaded the configuration file. This is used
for security and licensing purposes.
2. Press SELECT …
SSEriAL is displayed.
3. Press SELECT …
The 1st half of the serial number of the creating application of the
configuration file is displayed.
4. Press ZERO to show the 2nd half.
5. Press F1 …
SSEriAL is displayed.
6. Press UNITS …
dSEriAL is displayed.
7. Press SELECT …
The 1st half of the serial number of the downloading application of the
configuration file was downloaded to, is displayed.
8. Press ZERO to show the 2nd half.
9. Press F1 …
dSEriAL is displayed.
To Next Page
Loading...