T401S Indicator User Instructions 55
8.5 Batching application supervisor menu
2. Press UNITS …
bAtch is displayed. Use this to set the items relating to batching:
l Select auto or manual operation. (ModE)
l Set gross or net display mode. (diSP)
See Notes on batching on page 56 for information about settings for batching.
Mode
Batch Mode
3. Press SELECT …
ModE is displayed. Mode has two choices: Auto or MAnuAL. There is a
detailed description for each type in the section titled Batching
application on page 21
4. Press SELECT …
The current setting is displayed.
5. Press UNITS to toggle between the choices and when your choice is
displayed, press ZERO to accept …
ModE is displayed.
Display
Batch Mode Display
6. Press UNITS …
diSP is displayed. Display has two choices: NEt or GroSS. Each is
explained below:
NEt Choose Net to base batching on net weights.
GroSS Choose Gross to base batching on gross weights.
7. Press SELECT …
The current setting is displayed.
8. Press UNITS to toggle between the choices and when your choice is
displayed, press ZERO to accept …
diSP is displayed.
To Next Page
Loading...