Operating basics
Logamatic EMS RC35 user interface - Subject to technical modifications.14
4
4 Operating basics
4.1 Overview of operation
Legend for figure:
1 Cover: Pull the recessed grip on the
left to open
2 Display
3 Dial for changing values and
temperatures or for navigating
through the menus
4 Buttons for basic functions: When the LED lights up ...
“AUT” (automatic) • ... the program is active (automatic switchover between day and
night room temperatures).
“Day mode” (manual) • ... the heating system operates at the set day room temperature.
DHW heating is switched on (factory setting).
“Night mode” (manual) • ... the heating system operates at the set night setback room
temperature. Frost protection is active. DHW heating is
switched OFF (factory setting).
“DHW” (domestic hot water) • ... the DHW temperature has fallen below its set value while in
setback mode. The DHW can be heated up again (single
change) by pressing the button (the LED will then flash).
5 Buttons for
additional functions:
Function:
“Menu/OK” Open the user menu and confirm the current selection.
Turning the dial while pressing the button will change the value.
“Time” Set the time.
“Date” Set the date.
“Temperature” Set the room temperature.
“Info” Open the Info menu (to view values).
“Back” Go back one step or one menu item.
In Automatic mode, an additional LED lights up with the “AUT” LED to indicate which operating status is
currently active (“day mode” or “night mode”). The “domestic hot water” LED can also be disabled.
To Next Page
Loading...
Need help?
General
