Logamatic EMS RC35 user interface - Subject to technical modifications. 47
Reset
9
9 Reset
The SERVICE MENU\RESET resets the following:
• All parameters back to their factory settings
• Fault list
• Service messages
• The run time.
B Turn the dial to select a menu, e.g. fault list. Press to go to the relevant screen, e.g.
Confirm resetting the list of faults. Press and turn the dial to set the display to yes.
When the button is released, the reset is carried out.
During this process, a corresponding message appears, which disappears again automatically.
B Once reset is complete: confirm by pressing any of the buttons.
After resetting parameters to the factory setting, the parameters may need to be
adjusted again to suit the system configuration.
To Next Page
Loading...
