Service
Logamatic EMS RC35 user interface - Subject to technical modifications.46
8
8 Service
The servicing menu is used to set a service interval and to view and reset current service messages.
The interval can be set to expire either after a given number of operating hours or when a given date
is reached. The RC35 will then show a message so that the customer can notify the heating
contractor to arrange an appointment.
Service messages are indicated by an Hxx code, e.g. H07.
SERVICE MENU\
SERVICE Menu item Input range
Factory
setting
Other
information
service interval How should
servicing
messages be
triggered?
no messages,
by run time,
by date
no
messages
Selecting “run time”
or “date” takes you
automatically to the
corresponding
setting.
For “by date”:
Annual servicing,
starting on:
01/01/2009 01/01/2009 To set the date:
hold down and
turn the dial at the
same time.
For “by operation
hours”:
Boiler operation
hours until next
servicing message
1000 h – 6000 h 6000 h Number of hours of
operation with burner
switched on
current messages Message/code To view further
messages: turn the
dial.
RESET service Confirm resetting
the service
messages.
no, yes no If you select “yes” the
servicing messages
will be reset.
Observe information
in display.
Tab. 20 Navigator for the Servicing menu
To Next Page
Loading...
Need help?
General
