Buderus Logamatic EMS - Page 16

Operating basics
Logamatic EMS RC35 user interface - Subject to technical modifications.16
4
5.
Turn the dial counter-clockwise until system data is
selected (marked with).
Press to select system data.
6.
To change the value, hold down the button (the value
starts flashing) and turn the dial at the same time.
7.
Release the button.
The value stops flashing. The modified value is saved.
8. If you have carried out this example as practice only, make
sure that the original setting is retained.
To do so, repeat steps 6 and 7 if necessary.
9.
Press to go back one step.
-or-
To finish entering settings, shut the cover.
The standard display re-appears.
You can enter all settings in the SERVICE MENU using this procedure.
Operating Instructions Result
Tab. 4 How to use the Service menu (example)
SETTINGS\BOILER
What type of building
do you have?
medium
SETTINGS\BOILER
What type of building
do you have?
medium
SETTINGS\BOILER
What type of building
do you have?
light
SETTINGS\BOILER
What type of building
do you have?
medium