Figure 2. Wrapping the Cable
Butterfly iQ/ iQ+ Butterfly iQ3
15.2. Cleaning and Disinfecting the Probe at the Point-of-Use
WARNING!
Failure to disinfect the probe may result in an increased spread of pathogens.
CAUTION!
Only clean the probe with approved cleaning products and wipes. Improper cleaning or
disinfection methods or using non-approved cleaning and disinfecting solutions may damage
equipment.
This section provides information and instructions for properly cleaning and disinfecting the Butterfly iQ/ iQ+/ iQ3
probe. Following these instructions will also help to avoid damaging the probe during cleaning and disinfection. After
each exam, promptly clean and disinfect the Butterfly iQ/ iQ+/ iQ3 per the instructions below to prevent drying of soil
and contaminants in and on the device.
While the Cleaning and Disinfection guidance contained here has been validated for effectiveness, a list of
cleaning and disinfection products that are compatible with the Butterfly iQ/ iQ+/ iQ3 probe, but not tested for
effectiveness by Butterfly, can be found in the "Compatible Cleaning and Disinfection Products" article available at
support.butterflynetwork.com. The products listed in the Compatible Cleaning and Disinfection Products article will
not impact the functionality of the probe when used according to the instructions provided by the manufacturer of the
product.
Cleaning and Disinfecting the Probe at the Point-of-Use
Maintenance 76
To Next Page
