140 4-4 Starting and Driving
■ If the EPB switch is pressed and the vehicle is powered off at the same
time, the EPB will not be applied automatically. This function may be used
for towing or pushing the vehicle after the vehicle breaks down.
■ Do not release the brake pedal early in the process, especially when the
vehicle is to be parked on a slope; otherwise, there will be risk of vehicle
sliding to slight extent.
■ This function is designed to improve the vehicle safety. Excessive reliance
on or frequent use of the function is not recommended. To ensure safety,
make sure that the shift knob is in P position or the EPB is pulled up before
getting off the vehicle.
■ Within several seconds after the vehicle is started, the EPB system will
conduct self-check upon power-up. In this process, the EPB will not
respond to any function.
Releasing the EPB manually
■ When the vehicle is in OK mode or started and the vehicle is in a gear
position other than P (parking) position, depress and keep holding the
brake pedal and press the EPB switch until the indicator on the instrument
is off, which indicates that the EPB has been released, and then the
instrument will display the message of "EPB deactivated".
■ P position refers to the parking position. When the vehicle is in P position, it
is in a stable parking state. EPB is a main parking device of the vehicle. To
ensure the vehicle's parking safety, releasing the EPB with the EPB switch
can only be achieved when the vehicle is in a gear position other than P
(parking) position.
Releasing the EPB automatically when the vehicle is starting to move
■ With the vehicle parked, start the vehicle, depress and hold the brake pedal,
and shift to D position or R position from P position or N position, and then
the EPB will be released automatically, the indicator will go out, and the
instrument will display the message of "EPB deactivated".
■ Please follow the correct shift instructions and keep depressing the brake
pedal throughout the shifting process. Do not release the brake pedal until
the gear position shown on the instrument is the target one.
To Next Page
Loading...
