BYD ATTO 3 - Wiper Switch

86 3-4 Switches
Lighting prolong function
■ Lighting prolong function for homing:
● The driver can set the time for lighting prolong function for homing in
the multimedia interface and the default time is 10s. When the light
handle of the multi-function switch is turned to " ", " " or " "
and the driver powers the vehicle OFF, locks all the doors and intends
to leave the vehicle, the corresponding lights will continuously
illuminate for 10s (or the set time) for lighting.
■ Lighting prolong function for leaving home:
● The driver can set the time for lighting prolong function for leaving
home in the multimedia interface and the default time is 10s. When the
light handle of the multi-function switch is turned to " ", " " or
" " and the driver unlocks the vehicle and intends to get close to the
vehicle, the corresponding lights will illuminate for 10s (or the set time)
for lighting.
Wiper Switch
Wiper and washer for front windshield
■ This lever is used to control the
wiper and washer for windshield.
The control level has five control
modes:
● : high-speed wiping
● : low-speed wiping
● : intermittent wiping
● : stop
● : point wiping
■ To select a mode, raise or lower the control lever to a desired mode.
■ In the LO or HI mode, the wiper will wipe continuously.
■ To enable the wiper to operate in the MIST mode “▽”, pull down the control
lever from the “ ” mode. The wiper will wipe at a low speed until you
release the control lever.