■ In the INT mode " ", you can turn
the INT control knob on the wiper
switch. As the rainfall indicator bar
narrows, the wiping intervals will
also be prolonged.
Washer for front windshield
1. To clean the front windshield, pull
the control lever backward (close
to the steering wheel) to enable
the washer to spray washing fluid
and the wiper to operate at the
same time.
2. When you release the control
lever or the control lever has
operated continuously for more
than 10s, the washer will stop
spraying, while the wiper will wipe
1~2 more times before stopping
and wipe once about 5s later to
clear residual water on the
windshield.Remove residual water
droplets from the glass.
■ Turn the knob at the end of the
wiper switch to " " to activate the
wiper for rear windshield. Turn the
knob to " " or open the trunk lid to
stop the wiper.
To Next Page
Loading...
