144 4-4 Starting and Driving
■ AVH function can be activated only when all these operating conditions are
met.
■ When the gear is shifted from D position to R position, the system will enter
the vehicle moving mode. At the moment, the AVH function is not activated.
When the AVH button is pressed or the vehicle speed exceeds 10 km/h,
the system will exit the vehicle moving mode.
Low-speed vehicle moving mode
■ Enter the low-speed vehicle moving mode by engaging R gear. At this time,
the AVH function enters the state of vehicle moving mode. When the
vehicle at R gear reverses at low speed, or when the D gear is switched to
drive at low speed, the AVH is in the inhibition activation state, so as to
improve the smoothness of vehicle moving.
■ After entering the vehicle moving mode, the AVH function can be activated
normally by pressing the AVH switch, or exiting the vehicle moving mode
when the vehicle speed exceeds 10km/h.
Main Points of Driving
■ Drive the vehicle slowly and maintain a correct angle as much as possible
when driving on road with curbstones. Avoid driving the vehicle over
objects with high and sharp edges or over other obstacles on the road.
Otherwise, serious damages will be caused to the tires.
■ Slow down when driving on a bumpy road. Otherwise, wheels will be
seriously damaged by impact.
■ Avoid driving the vehicle through the waterlogged road surface when the
vehicle has to be driven on a wet road.
■ Drive slowly when driving against the wind, because it is easy to control the
vehicle by doing so.
■ The brake may be get wet when you wash the vehicle or drive the vehicle
through deep water. In this case, carefully drive and depress the brake
pedal gently to dry the brake.
■ When the vehicle is on a road with poor adhesion surface such as snow,
sand, wet tiles or wet epoxy resin, please try to avoid parking on the ramp
to avoid sliding accidents.
To Next Page
Loading...
