EasyManua.ls Logo

BYD ATTO 3 - Washing the Vehicle

BYD ATTO 3
270 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6-2 Regular Maintenance 217
6
Service and Maintenance
■ Wax the painted surface for protection once a month or when the vehicle
body surface do not have goo water-resistant performance and regularly
drive the vehicle to a professional automobile beauty shop for maintenance
(once a quarter) to recover the brightness and glossiness of the painted
surface of vehicle body.
■ Use high-quality polishing agent and vehicle wax. If the vehicle's polished
surface is found with serious wreathing effect, use a vehicle cleaning and
polishing agent separate from vehicle wax. Observe the manufacturer's
specifications carefully and take specified preventive measures. The
chrome plated surface should be polished and waxed the same as the
painted surface.
Attention
■ If the vehicle is to be re-painted and parked in a high-temperature painting
and waxing workshop, the vehicle's plastic bumper should be removed,
because high temperature may damage the bumper.
Washing the Vehicle
■ Driving under the following conditions will cause peel-off of the paint coat or
corrosion of the vehicle body and parts, so the vehicle must be washed in
time:
● When you are driving in coastal areas.
● When you are driving on a road distributed with antifreeze agent;
● When you are driving on a road with coal tar;
● When any resin, bird dropping or dead body of insect is left on the
vehicle body;
● When you are driving in the areas containing a large amount of smoke,
coal ash, dust, scrap iron or chemical substances;
● When the vehicle is obviously contaminated by dust and mud;
● When you are driving after raining.
Manual washing
Be sure to wash the vehicle at a shady and cool place and after the vehicle fully
cools down.
1. Wash away loose dirt with a water hose, and wash off all mud or road salt
and alkali at the bottom of vehicle body and in the recessed positions of
wheels.

Table of Contents