BYD PMW20 - 5.1 REMOVE AND INSTALL THE OPERATING HANDLE

PMW20
42
PMW20
43
2 Install
Follow steps in reverse order to install the the main bearing of compound rollers.
Note
Main and side rollers, and dust-proof ring are mounted to the front end of compound
rollers of door bracket through circlips. The side roller is used to adjust the space by
the adjustment screw on the other side. The anti-looseness piece is used to protect the
adjustment screws.
1) Bend the anti-looseness piece until the adjustment screw exposes out.
2) Use the adjustment screw to adjust the guide space of the lift mechanism of the
rear forklift body.
3) Bend the anti-looseness piece to protect the adjustment screw after adjustment.
2) Remove the Circlips for shaft and use an appropriate tool to remove the main
bearing of compound rollers.
A
A
A
A
< A >
81
82
83
86
85
84
SM-PMW202020001-EN
SM-PMW202020001-EN
CODE PART NAME QTY OTHER INFORMATION
81 MAIN BEARING OF COMPOUND ROLLERS 4
82 SIDE BEARING OF COMPOUND ROLLERS 4
83 DUST-PROOF PIECE OF COMPOUND ROLLERS 4
84 ANTI-LOOSENESS PIECE OF COMPOUND ROLLERS 4
85 ADJUSTING SCREW OF COMPOUND ROLLERS 4
86 CIRCLIPS FOR SHAFT 4