PMW20
129
2. Error ID: 02A00
Error Description: DATA ACQUISITION
In case of several faults, check the internal faults of traction and steering control. Cause A
If the fault is activated to show that it is in a phase of data acquisition, please wait until data
is acquired completely.
Handling Method: In the process of adjusting the maximum current of the controller. Note:
The error only appears when testing the Zapi. If it is found in the user, replace the controller.
For the P20JW forklift, the main controller is COMBIACX.
If the display shows the error 02A00 and the error is detected on the host computer,
replaced the faulty controller.
PMW20
128
8.8 ELECTRICAL MAINTENANCE DIAGNOSIS
In this section, you can read the error codes through MDI display. The error code of the
controller is shown as 02AXX, the error code of the steering controller is shown as
06AXX and the error code of the display is shown as 17AXX.
Analyze and detect the reading information and therefore finishing the maintenance of the
forklift.
If the forklift works abnormally, read error codes on the MDI display first and then check the
current error codes in ALARM.
for the error
SM-PMW202020001-EN
SM-PMW202020001-EN
Use the BYD forklift to read the
current fault codes
and the record information of
the historical faults.
If there are no error codes in ALARM, then check the error record table
code in the recent history records.
1. Error ID: 02A66
Error description: BATTERY LOW
Cause A:
When the battery level is less than 10%, it alarms. Meanwhile, the speed will decline and
the lifting function is prohibited.
M1: Use the multimeter to detect the battery voltage.
If parameters of "BATTERY CHECK" are not set as "0", the error will be reported, and the
lifting function will be locked when the battery power is less than 15% and no bars are
displayed on the display. Please charge in time. If the battery is electric, check whether
the value of "ADJUST BATTERY" on the controller is consistent with that of battery
voltage.
For ADJUST BATTERY, the current voltage can be acquired automatically. When the
battery level is not accurate, click "Acquire" and then store it, as shown in the following
figure.
To Next Page
Loading...
